FREE COURIER SHIPPING! SPEND R500 TO QUALIFY.

Chakra Healing With A Crystal Wand

How to balance the chakras with a crystal wand

Find out how to Balance the Chakras with a Crystal Wand easily! In this article, we will teach you how to do a full Chakra balancing and healing session with your crystal wand.

Following on from our article about what crystal wands are, how they work and what they are used for (READ HERE) – this is an excellent introduction into crystal healing with a crystal wand. Following the steps below you will learn how to do a full chakra balancing session using your crystal wand.

Step 1: Choose Your Tools

At a basic level, all you need to complete this healing is a Neutral Crystal Wand, or any crystal wand that you are strongly attuned with, and a pendulum. Everything else is optional.

3 Energy Types of Crystal Wands

Read “3 ENERGY TYPES OF CRYSTAL WANDS” to find out more about Neutral, Balancing & Activating Crystal Wands.

READ

Choose a neutral crystal wand. Clear Quartz crystal (Rock Crystal) is an excellent go-to. You might want to have a balancing crystal wand (eg Blue Calcite) and an activating crystal wand (eg Selenite) on hand should you need them after the first pass. 

Neutral Crystal Wands in Stock

Balancing Crystal Wands

Activating Crystal Wands

If you are not 100% sure which wand to work with, or you don’t have a specific type of crystal wand, then use the wand you are most strongly in tune with. 

Tourmaline pendulum

Have your crystal pendulum handy for checking the chakras after balancing.

SHOP PENDULUMS

SUMMARY OF TOOLS:

  • Neutral Crystal Wand
  • Crystal Pendulum
  • Balancing Crystal Wand & Activating Crystal Wand (OPTIONAL)
  • Crystal Chakra Kit / stones for each chakra (OPTIONAL)
  • Kyanite or other unblocking crystal (OPTIONAL)
  • Clear Quartz Crystal (“rock crystal”) (OPTIONAL)
  • Chart of chakras on body (OPTIONAL)

STEP 2: Perform The First Pass

OPTIONAL: Place a crystal corresponding to each chakra on the body. Tumbled stones, rough pieces/chunks or gallets all work nicely. Try to have all the chakra crystals of relatively the same size, and flattish so that they do not roll off or move around on the body.

  • Starting at the root or base chakra, spiral the wand in a clockwise (‘deosil’) motion to activate and balance the chakra. 
  • Spend a few moments on this chakra until you feel ready to move on to the next.
  • Continue up the body in the same way until you complete the seventh chakra at the crown.

You may feel at this point that the treatment is complete and the chakras are balanced. If you intuitively feel this, you can close off the session. If not, continue as below.

STEP 3: Pendulum Scan and Chakras Second Pass

  • Use a pendulum to confirm that each chakra is now in balance by holding the pendulum over the chakra (again starting at the root), and asking for a ‘yes’ response from your pendulum if the chakra is balanced. 
  • You can hold you pendulum over the body, or use a chakra chart next to you if you prefer.
  • Once you get a clear ‘yes’ response, move on to the next chakra to check.
  • If you get a ‘no’ or ‘maybe’ response, repeat the crystal wand process (spiraling clockwise over the chakra) before rechecking with the pendulum.
  • If you get a clear yes, move on to the next chakra until all chakras have been checked and confirmed balanced.

You may feel at this point that the treatment is complete and the chakras are balanced. If you intuitively feel this, you can close off the session. If not, continue as below.

STEP 4: Pendulum Scan and Chakras Final Pass

If you still get a ‘no’ or ‘maybe’ on a chakra, try asking the following questions. A ‘yes’ will indicate what the underlying issue is.

CLARIFY THE ISSUE WITH THESE QUESTIONS:

  • BLOCKAGE: Is there a blockage in the chakra?
  • OVERACTIVE: Is the chakra overactive?
  • UNDERACTIVE: Is the chakra underactive?

Once you have an answer as to what the underlying issue is, you can then use the Troubleshooting guide below.

Troubleshooting:

IF THE CHAKRA IS BLOCKED

If the chakra is blocked, you can use the wand to scan the chakra and identify the blockage, then remove it by turning the wand in the opposite direction to draw off energy. Then proceed to activate and balance the chakra again by spiraling clockwise over the chakra with the wand.

OPTIONAL: Place a Kyanite (or another crystal with unblocking & clearing properties) next to the chakra stone to boost and amplify the energy as you work.

OVERACTIVE CHAKRA

If the chakra is overactive, try spiraling the wand slowly in an anticlockwise (windershins) motion until you feel it is complete, before rechecking with the pendulum. If you have a balancing wand set aside, you would want to use it now. A calming, balancing wand like Blue Calcite is a great choice. Alternatively, proceed with the wand you feel most attuned to. Keep the purpose of the working very clear in your mind.

OPTIONAL: place a calming, soothing crystal next to the chakra stone to amplify the energy as you work.

UNDERACTIVE CHAKRA

If the chakra is underactive, spiral the wand in a faster motion clockwise over the chakra until you feel it is complete, before rechecking with the pendulum. If you have an activating wand set aside, you would want to use it now. Tiger’s Eye or Red Jasper would be good choices. Alternatively, proceed with the wand you feel most attuned to. Keep the purpose of the working very clear in your mind.

OPTIONAL: place a clear Quartz crystal (Rock Crystal) next to the chakra crystal to boost and amplify its effect as you work.

SHARE THIS

Share on facebook
Share on twitter
Share on pinterest
Share on whatsapp
Share on email
Share on print

READ NEXT